Heatrae Sadia 95.020.114 Hand Wash Water Heaters – Shop4 Electrical

Description

Features:

Consistent, splash free spray pattern
Flow/temperature stabilised for constant outlet temperature
Two levels of over temperature protection
Excessive pressure protection
New model is retro-fit to previous Heatrae Sadia Handy models
15mm female ‘Push Fit’ connection to water supply
The single-turn rotary control dial is easy to operate, controlling both the temperature and flow rate of the water
These units offer comprehensive safety protection against the dangers of both scalding and excessive pressure build-up within the unit
Two level cut-out. The first level cut-out operates at 52C and will re-set when the water has cooled down to 42C. The second level of protection operates in extreme conditions and cuts out at 92C and is not re-settable
The flow/temperature stabiliser ensures that a consistent outlet temperature is maintained even in conditions of variable water pressure
The pressure relief device ensures that in the case of freezing or blockage, pressure is not allowed to build up to dangerous levels within the unit
Extended Spout (380mm) is available as an Accessory
2 year guarantee

Rating
Handy 7 7.2kW @ 240V (6.6kW @ 230V).

Controls
Handy 3/7 Single turn rotary control dial for on / off, temperature and flow setting.

Outer casing
White moulded ABS plastic cover.

Heat unit
Copper sheathed rod-type element.

Water container
Glass reinforced nylon.

Safety features
Self-resetting thermal cut-out set at 52C for over heat protection. Non self-resetting second stage cut-out set at 92C. Pressure relief device in the base of the container to prevent high-pressure build-up. Flow / temperature stabiliser maintains consistent outlet temperature under variable water pressure conditions. Pressure sensor cuts off power if flow is inadequate.

Ingress protection
IPX5

Approvals
Handy 3/7 BEAB and Kiwa approved to UK water supply regulations. CE marked.
Handy No Touch Kiwa approved to UK water supply regulations. CE marked.

Fixing
Base assembly is secured to wall by two fixing screws, followed by electrical and plumbing connections. The spout and front cover are then attached. Two screws secure the front cover.

Plumbing
15mm female push fit at the base of the unit for bottom or rear (concealed) entry. Incoming feed pressure should be between 0.1Mpa (1 bar-14.5psi) and 0.7Mpa (7 bar-100psi).

Electrical
Cable entry from rear or bottom of unit. Special requirements of the BS 7671 (IEE Wiring Regulations) should be observed when installed in bathrooms. Units must be permanently connected to the electrical supply through a double-pole linked isolating switch. Handy 3 and Handy No Touch can be supplied from a ring final circuit via a fused spur with a double pole linked isolating switch with a 13A minimum breaking capacity.
Cable 1.52.5mm. The 7.2kW Handy requires a dedicated circuit and switch rated at 30A minimum. All electrical work must comply with the latest edition of BS 7671 (IEE Wiring Regulations).

Dimensions: